[Jun 29, 2021] Updates Up to 365 days On Valid 300-425 Braindumps
Best Quality300-425 Exam Questions Cisco Test To Gain Brilliante Result
NEW QUESTION 26
A wireless engineer is designing a wireless network for a warehouse using access points with internal antennas. Which two elements have a negative effect on the wireless users? (Choose two.)
- A. wireless channels
- B. access point height
- C. absorption
- D. client authorization
- E. client authentication
Answer: B,C
Explanation:
https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1250-series/design_guide_c07-693245.html#_Toc309331086
NEW QUESTION 27
A customer is running a guest WLAN with a foreign/export-anchor setup. There is one anchor WLC in the US and two in Europe. Anchor WLC priorities are used to prefer local anchors. During a routine network audit, it is discovered that a large number of guest client sessions in the US are anchored to the WLCs in Europe. Which reason explains this behavior?
- A. The US anchor WLC failed and recovered.
- B. The anchor WLC is in the same mobility group.
- C. The foreign WLC failed and recovered.
- D. The US anchor WLC is anchored to itself with a priority value of zero.
Answer: A
NEW QUESTION 28
An engineer has successfully configured high availability and SSO using two Cisco 5508 Wireless LAN Controllers. The engineer can access the Active Primary WLC, but the Secondary Standby WLC is not accessible. Which two methods allow access to the standby unit? (Choose two.)
- A. SSH to the service port interface
- B. via the console connection
- C. SSH to the redundancy management interface of the primary WLC
- D. SSH to the management interface of the primary WLC
- E. SSH to the virtual interface of the secondary WLC
Answer: A,B
Explanation:
NEW QUESTION 29
Drag and drop the characteristics from the left onto the correct functionalities on the right.
Answer:
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONS
NEW QUESTION 30
An engineer has successfully configured high availability and SSO using two Cisco 5508 Wireless LAN Controllers. The engineer can access the Active Primary WLC, but the Secondary Standby WLC is not accessible. Which two methods allow access to the standby unit? (Choose two.)
- A. SSH to the service port interface
- B. via the console connection
- C. SSH to the redundancy management interface of the primary WLC
- D. SSH to the management interface of the primary WLC
- E. SSH to the virtual interface of the secondary WLC
Answer: A,B
Explanation:
NEW QUESTION 31
A high-density wireless network is designed. Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?
- A. RRM
- B. load balancing
- C. Cisco Centralized Key Management
- D. Band Select
Answer: D
Explanation:
NEW QUESTION 32
A wireless engineer is utilizing the voice readiness tool in Cisco Prime for a customer that wants to deploy Cisco IP phones. Which dBm range is the network inspected against?
- A. -85 to -65 dBm
- B. -72 to -67 dBm
- C. -78 to -65 dBm
- D. -85 to -67 dBm
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/34/user/guide/bk_CiscoPrimeInfrastructur minimum is -90 and maximum is -67 for IP phone
NEW QUESTION 33
An engineer must speed up the reauthentication delays that are being experienced on the wireless infrastructure by deploying a key-caching mechanism. Which mechanism must be configured?
- A. PMF
- B. PEAP
- C. GTK-randomization
- D. FT
Answer: D
Explanation:
NEW QUESTION 34
Which UDP port numbers are used for exchange mobility packets in an AireOS wireless deployment?
- A. UDP 16666 for control plane, UDP 16667 for data plane
- B. UDP 16666 for control plane, EoIP (IP protocol 97) for data plane
- C. UDP 16667 for control plane, UDP 16666 for data plane
- D. UDP 16668 for control plane, UDP 16667 for data plane
Answer: A
Explanation:
NEW QUESTION 35
An engineer must ensure that the new wireless LAN deployment can support seamless roaming between access points using a standard based on an amendment to the 802.11 protocol. Which protocol must the engineer select?
- A. 802.11r
- B. 802.11ac
- C. 802.11i
- D. 802.11e
Answer: A
NEW QUESTION 36
A network engineer is configuring high availability on an access point. What is the maximum number of controllers that can be configured?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
Explanation:
Explanation
So max 2 will be supported on an AP.
NEW QUESTION 37
A rapidly expanding company has tasked their network engineer with wirelessly connecting a new cubicle area with Cisco workgroup bridges until the wired network is complete. Each of 42 new users has a computer and VoIP phone. How many APs for workgroup bridging must be ordered to keep cost at a minimum while connecting all devices?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
Explanation:
Explanation
So, each AP will have 25 clients. Minimum 4 APs are sufficient.
NEW QUESTION 38
A network engineer needs to create a wireless design to bridge wired IP surveillance cameras m the parking lot through a mesh AP To which operate mode of the AP should the cameras connect?
- A. local
- B. FlexConnect
- C. RAP
- D. MAP
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/mesh-access-points.html
NEW QUESTION 39
An engineer changed me TPC Power Threshold for a wireless deployment from the default value to -65 dBm The engineer conducts a new post deployment survey to validate the results What is the expected outcome?
- A. decreased channel overlap
- B. increased received sensitivity
- C. increased cell size
- D. decreased client signal strength
Answer: D
NEW QUESTION 40
A company wants to replace its existing PBX system with a new VoIP System that will include wireless IP phones. The CIO has concerns about whether the company's existing wireless network can support the new system. Which tool in Cisco Prime can help ensure that the current network will support the new phone system?
- A. Site Calibration
- B. Location Readiness
- C. Voice Readiness
- D. Map Editor
Answer: C
Explanation:
NEW QUESTION 41
Clustering Cisco WLCs into a single RF group enables the RRM algorithms to scale beyond the capabilities of a single Cisco WLC. How many WLC and APs in an RF group can the controller software scale up to in WLC release 8.9 depending on the platform?
- A. up to 20 WLCs and 3000 APs
- B. up to 20 WLCs and 1000 APs
- C. up to 20 WLCs and 6000 APs
- D. up to 20 WLCs and 4000 APs
Answer: C
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-9/config-guide/b_cg89/radio_resource_management
NEW QUESTION 42
A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3x3 MIMO. Which reason explains this behavior?
- A. A redundant power supply is unavailable on the switch.
- B. The switch is 802.3af capable.
- C. The AP is getting power from a power injector.
- D. The switch is PoE+ capable.
Answer: B
Explanation:
NEW QUESTION 43
A customer has determined that aesthetics is a primary concern for their upcoming guest deployment. Which design consideration can be leveraged to address this concern?
- A. Use enclosures to hide the wireless infrastructure in the surrounding environment.
- B. Use AIR-AP-BRACKET-1 to allow for greater mounting locations
- C. Paint the access point to cover the LED from being noticeable.
- D. Deploy environmentally friendly cabling components to blend into the environment.
Answer: D
Explanation:
NEW QUESTION 44
Which CLI command does an engineer use to validate that the redundancy peer of a Stateful Switchover pair of controllers is up and connected?
- A. eping
- B. mping
- C. rping
- D. ping
Answer: D
Explanation:
NEW QUESTION 45
......
Focus on 300-425 All-in-One Exam Guide For Quick Preparation: https://www.passleader.top/Cisco/300-425-exam-braindumps.html
Tested Material Used To 300-425: https://drive.google.com/open?id=1vqzXBAUuCejtOIbKyKQrrn3qR6oxW07L