Get Ready with JN0-682 Exam Dumps (2023)
Realistic JN0-682 Dumps are Available for Instant Access
NEW QUESTION 78
What is the purpose of the command shown in the exhibit?
- A. To disable the group2390.0.1 across the entire VXLAN.
- B. To stop the transmission of transit multicast traffic when there are no interested receives attached to a
remote VTEP - C. To stop the reception of transit multicast traffic when there are no interested receives attached to the
local VTEP - D. To disallow IGMP request for the group 239.0.01 from host attached to the local VTEP
Answer: B
Explanation:
Explanation
https://www.juniper.net/documentation/en_US/junos/topics/topic-map/sdn-vxlan.html
"no traffic will be forwarded for the specified group but all other multicast traffic will be forwarded"
NEW QUESTION 79
Which two statements are correct about a spine and leaf-based IP fabric? (Choose two.)
- A. Leaf switches broadcast frames to all other leaf devices.
- B. Traffic is diverted within the fabric when a device or link fails.
- C. Clos networks demonstrate good scaling features.
- D. There is no need for redundancy at the server level.
Answer: A,B
NEW QUESTION 80
Application developers are complaining that east-west server traffic is not being load balanced in your new data center. What are three reasons for this behavior? (Choose three.)
- A. There is insufficient spine to leaf bandwidth.
- B. MP-BGP is not exporting the correct prefix type.
- C. Policies for load balancing have not been configured.
- D. ESI active/active has not been configured.
- E. BGP multipath is not configured.
Answer: A,B,D
NEW QUESTION 81
You are logged in to Leaf 1. When examining the routing table, you notice that you have no routes from Leaf 2.
Referring to the exhibit, which two commands would you use to troubleshoot the problem?
(Choose two.)
- A. From Leaf 2, issue the show route advertising-protocol bgp 172.16.1.2 command.
- B. From Leaf 1, issue the show route receive-protocol bgp 172.16.1.1 command.
- C. From Spine 1, issue the show route advertising-protocol bgp 172.16.1.2 command.
- D. From Spine 1, issue the show route advertising-protocol bgp 172.16.1.1 command.
Answer: B,C
NEW QUESTION 82
Application developers are complaining that east-west server traffic is not being load balanced in your new data center. What are three reasons for this behavior? (Choose three.)
- A. Policies for load balancing have not been configured.
- B. BGP multipath is not configured.
- C. ESI active/active has not been configured.
- D. There is insufficient spine to leaf bandwidth.
- E. MP-BGP is not exporting the correct prefix type.
Answer: A,B,C
NEW QUESTION 83
Exhibit.
The configuration shown in the exhibit is intended to set up assisted replication but will not commit.
Which action will create a valid configuration in this situation?
- A. Change the replicator inet address to 192.168.100.101.
- B. Delete replicator inet 192.168.100.1.
- C. Change the 10.0 address to 192.168.100.1 primary.
- D. Change the replicator inet address to 192.168.100. 51.
Answer: D
NEW QUESTION 84
What is the purpose of the command shown in the exhibit?
- A. To disable the group2390.0.1 across the entire VXLAN.
- B. To stop the reception of transit multicast traffic when there are no interested receives attached to the local VTEP
- C. To stop the transmission of transit multicast traffic when there are no interested receives attached to a remote VTEP
- D. To disallow IGMP request for the group 239.0.01 from host attached to the local VTEP
Answer: C
NEW QUESTION 85
A VXLAN has been created between devices leaf1 and Ieaf3.
Referring to the exhibit, which statement is true?
- A. Traffic sent from host1 to host2 will be dropped on leaf1.
- B. Traffic sent from host1 to host2 will be tagged with VLAN ID 100 when exiting Ieaf3.
- C. Traffic sent from host1 to host2 will be tagged with VLAN ID 200 when exiting Ieaf3.
- D. Traffic sent from host1 to host2 will be dropped on Ieaf3.
Answer: B
NEW QUESTION 86
You are asked to enable plug-and-play line card switches in an active VCF without making any future Junos configuration charges. You are also required to ensure that all new line card are automatically upgrade to the correct Junos version without any manual intervention. In this scenario, which two actions will accomplish this task? (Choose two.)
- A. Set the Virtual Chassis as per-provision before the line are inserted.
- B. Configure the auto-sw-update parameter on the VCF before inserting new line cards.
- C. Ensure that the newly instead card's MAC addresses are present in the DHCP configuration for ZTP.
- D. Set the virtual Chassis as auto-provisioned before the line cars are inserted.
Answer: B,D
NEW QUESTION 87
Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP.
Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24
network into EBGP. Spine 2 must be configured so that it can load-share traffic destined to the 10 1.1/24
network over both next-hop A and next-hop B.
Which two actions must be performed to accomplish this task? (Choose two.)
- A. Use multihop
- B. Use advertise inactive
- C. Use multipath multipath-As
- D. Use a load-balancing policy applied to the forward table
Answer: C,D
NEW QUESTION 88
Which two statements about the seamless EVPN-VXLAN stitching interconnect gateways are correct? (Choose two.)
- A. All EVPN routes types are forwarded among interconnect gateways in a full-mesh manner.
- B. IBGP is recommended for VXLAN stitching overlays.
- C. Interconnect gateways will rewrite the route target, route distinguisher. and ESI values for each stretched virtual network.
- D. The interconnect gateway can reside on the super spine layer of a multi-POD data center.
Answer: A
NEW QUESTION 89
You have deployed two data centers that require a Layer 2 stretch between host1 and host2.
Referring to the exhibit, what does a Layer 2 stretch require?
- A. A VXLAN tunnel originating on the super Spine Layer in DC1 to the Super Spine Layer in DC2
- B. A VPLS WAN connection data centers
- C. A VXLAN tunnel originating on the Spine Layer in DC1 to the Spine Layer in DC2.
- D. A VXLAN tunnel originating on VTEP1 to VTEP2
Answer: D
NEW QUESTION 90
You have deployed a VXLAN as shown in the exhibit Leaf1, leaf3, spine1, and spine2 have been configured as VTEPs. Host1 cannot communicate with host2.
Referring to the exhibit, how would you solve this problem?
- A. A DCI connected must be created between the VLANs
- B. The VLAN ID on the connected to host2 must be changed to VLAN 100
- C. Host1 and host2 must be placed in the same VRF
- D. A layer 3 VXLAN gateway must be configured on at least on at least one of the devices
Answer: D
NEW QUESTION 91
What are two streaming data formats supported for network analytics? (Choose two.)
- A. GPB
- B. JSON
- C. XML
- D. SLAX
Answer: A,B
NEW QUESTION 92
Referring to the exhibit, not all routes are being exchanged by EBGP peers.
In this scenario, which BGP parameter would solve this problem?
- A. as-override
- B. mulcihop
- C. mulcipach mulciple-as
- D. mulcipach
Answer: A
NEW QUESTION 93
Exhibit.
You are troubleshooting a problem with traffic not reaching a remote VTEP Referring to the exhibit, what is the reason for the problem?
- A. A conflict exists with the VLAN-to-VNI mapping.
- B. The remote VTEP does not have the correct VNI configured.
- C. No VTEP is configured on peer 192.0.2.20.
- D. The local VTEP is misconfigured with the wrong VNI.
Answer: B
NEW QUESTION 94
Exhibit.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. The remote leaf is using the 192.168.100.102 IP address as the local anchor point of the VTEP tunnel.
- B. The remote leaf is using the 192.168.100.101 IP address as the local anchor point of the VTEP tunnel.
- C. The local leaf is using the 192.168.100.101 IP address as the local anchor point of the VTEP tunnel.
- D. The local leaf is using the 192.168.100.102 IP address as the local anchor point of the VTEP tunnel.
Answer: B,D
NEW QUESTION 95
......
Juniper JN0-682 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
Download Exam JN0-682 Practice Test Questions with 100% Verified Answers: https://www.passleader.top/Juniper/JN0-682-exam-braindumps.html
Share Latest JN0-682Test Practice Test Questions, Exam Dumps: https://drive.google.com/open?id=1QAsaKsYTKT9mySRn9LT7JyS3CCfqR0V-